rtquery(1)

NAME
     rtquery - query routing daemons for their routing tables

SYNOPSIS
     rtquery [-np1] [-w timeout] [-r addr] [-a secret] host ...

     rtquery -t op host ...

DESCRIPTION
     Rtquery is used to query a RIP network routing daemon, routed(1M) or
     gated(1M), for its routing table by sending a request or poll command.
     The routing information in any routing response packets returned is
     displayed numerically and symbolically.

     Rtquery by default uses the request command.  When the -p option is
     specified, rtquery uses the poll command, an undocumented extension to
     the RIP specification supported by gated(1M).  When querying gated(1M),
     the poll command is preferred over the Request command because the
     response is not subject to Split Horizon and/or Poisoned Reverse, and
     because some versions of gated do not answer the Request command.  Routed
     does not answer the Poll command, but recognizes Requests coming from
     rtquery and so answers completely.

     Rtquery is also used to turn tracing on or off in routed.

OPTIONS
     -n   Normally network and host numbers are displayed both symbolically
          and numerically.  The -n option displays only the numeric network
          and host numbers.

     -p   Uses the Poll command to request full routing information from
          gated(1M).  This is an undocumented extension of the RIP protocol
          supported only by gated(1M).

     -1   query using RIP version 1 instead of RIP version 2.

     -w timeout
          changes the delay for an answer from each host.  By default, each
          host is given 15 seconds to respond.

     -r addr
          ask about the route to destination addr.

     -a passwd=XXX

     -a md5_passwd=XXX|KeyID
          cause the query to be sent with the indicated cleartext or MD5
          password.

     -t op
          change tracing, where op is one of the following.  Requests from
          processes not running with UID 0 or on distant networks are
          generally ignored by the daemon except for a message in the system
          log.  gated(1M).  is likely to ignore these debugging requests.

          on=tracefile
               turn tracing on into the specified file.  That file must
               usually have been specified when the daemon was started or be
               the same as a fixed name, often /etc/routed.trace.

          more increases the debugging level.

          off  turns off tracing.

          dump dumps the daemon's routing table to the current tracefile.

SEE ALSO
     routed (1M), gated(1M)
     RFC 1058 - Routing Information Protocol, RIPv1
     RFC 1723 - Routing Information Protocol, RIPv2